Revell 23954 Instrucciones de uso descargar pdf (Pagina 9)

English

5 START PREPARATION

Possible control modes for X Spy

X Spy can be controlled with the supplied remote control or with your smart phone.

The switch-on sequence determines whether the quadrocopter accepts your smart

phone or the remote control as the control medium. The quadrocopter must always be

switched on first. Then switch on the remote control or connect the smart phone to

theX-Spy‘sWLANnetwork.

3 INSERTING BATTERIES

3A To open the cover, lift

gently on the locking

mechanism.

3B Insert4x1.5VAA

batteries and pay

attention to the polarity,

as shown in the battery

compartment.

3C Close the cover again.

4 CHARGING THE MULTICOPTER

Attention: The battery and motor must cool down for 10 to 15 minutes before

charging and after every flight. Otherwise they can be damaged. The charging process

must be constantly monitored. Always ensure that the charging process takes place on

a fireproof surface in a fire-resistant environment.

•Unplugthemulticopterfromthebattery,switchofftheremotecontrolandplugthe

charger into an outlet. The control LED on the charger illuminates green (4A).

•Removethebatteryfromthebatterycompartment(donotholdbythecable!)(4B).

•NowplugthebatteryintothechargerPayattentiontothepolarity.Pleasedonotuse

force. The LED on the charger will light up red when charging begins (4C).

•Thechargingprocesslastsapprox.100minutesandmustbecontinuouslymonitored.

The red LED on the charger goes out as soon as the charging process is finished.

•Disconnectthebatteryfromthechargeranddisconnectthechargerfromthemains

after the charging is completed.

After a charge time of approx. 100 minutes the multicopter can fly for approx.

5 minutes.

Warning notice: The battery does not normally heat up while charging. If it should

become warm or even hot and/or changes to the surface begin to appear, immediately

discontinue the charging process!

2 REMOTE CONTROL

2A Trim buttons for rotation

2B Controller for thrust and

rotation

2C No function

2D No function

2E No function

2F Smart phone holder

2G Power-LED

2H Trim buttons for

f orwards and

backwards

2I Turbo button

2J Flip button

2K Controller for forward/

backward and sideways

flight

2L Trim button for

sideways flight

2M ON/OFF switch

2N Holder retaining screw

2O Holder retaining screw

2P Spring clamp for smart

phones

2Q Battery compartment

cover

Required app

Please download the Revell-XSpy app from App Store or Play Store. Tip: under certain

circumstances, iPad users do not see this app. To show this app, select the „iPhone

apps“option.PleaseestablishtheWLANconnectionbeforestartingtheapp.

(A) If you would like to fly using the remote control, switch on the quadrocopter first

by plugging the battery into the X Spy, then the remote control. The thrust controller of

the remote control must be all the way down. Two brief signal tones indicate that the

connection has been established and the remote control is activated.

If you would like to stream the video image of the quadrocopter to your smart phone,

youcannowconnectthesmartphonetotheWLANnetworkofthequadrocopter.

Nowstarttheapp.Theflightimageisdisplayedwitharesolutionof640x480pixels.

(B)Forcontrolviasmartphone,switchonthequadrocopterfirst.TheWLANnetwork

is created after approximately 30 seconds and the smart phone can be connected to

theXSpyWLANnetwork.TologintotheWLANnetwork,followingthesmartphone

manufacturer‘s instructions. Now the X Spy can be controlled with the controllers

shown on the display or using the smart phone position sensors.

Extending the antenna

For better reception, please take the antenna out of the mount and it turn it

downwards.

6 TRIM ADJUSTMENT OF THE CONTROL

The correct trim is a basic requirement for fault-free flying behaviour of the multicopter.

Its adjustment is simple, but it requires some patience and a feel for it. Please observe

the following instructions precisely: Carefully move the thrust control up and raise the

multicopter approximately 0.5 to 1 metre in altitude.

6A If the multicopter moves by itself slowly or quickly to the left or right …

press the trim adjustment for banking incrementally in the opposite direction.

6B If the multicopter moves by itself slowly or quickly around its own axis …

press the trim adjustment for rotation incrementally in the opposite direction.

6C If the multicopter moves by itself slowly or quickly forwards or backwards

…

press the trim adjustment for forward and backwards flight incrementally in the oppo-

site direction.

16 17

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Comentarios a estos manuales

Sin comentarios

Revell 23954 Instrucciones de uso Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Juguetes con control remoto Revell 23954